May 15, 2009

Updates were made to the following section. The changes are explained below.

Section A.2.1, “Managing Multipath I/O”

Managing Multipath I/O

The following changes were made to this section:

Location	Change
Section 5.8, “Configuring Multipath I/O for the Root Device”	DM-MP is available but is not supported for `/boot` and `/root` in SUSE Linux Enterprise Server 10 SP1 and later if all online updates have been applied. More specifically, you need `mkinitrd` 1.2-106.61 and `multipath-tools` 0.4.7-34.23 or later. However, if you install the packages and set up the configuration, you might run into update issues later. Full multipath support is available in SUSE Linux Enterprise Server 11.

Location

Change

Section 5.8, “Configuring Multipath I/O for the Root Device”

DM-MP is available but is not supported for /boot and /root in SUSE Linux Enterprise Server 10 SP1 and later if all online updates have been applied. More specifically, you need mkinitrd 1.2-106.61 and multipath-tools 0.4.7-34.23 or later. However, if you install the packages and set up the configuration, you might run into update issues later.

Full multipath support is available in SUSE Linux Enterprise Server 11.