| SUSE Linux Documentation Part I. Deployment / Chapter 3. Installation with YaST | ||||
|---|---|---|---|---|
 | 2.3. Deploying More than 100 Workstations | 3.2. IBM System z: System Start-Up for Installation |  | |
| SUSE Linux Documentation Part I. Deployment / Chapter 3. Installation with YaST | ||||
|---|---|---|---|---|
| 2.3. Deploying More than 100 Workstations | 3.2. IBM System z: System Start-Up for Installation | | |
Contents
Abstract
After your hardware has been prepared for the installation of SUSE Linux Enterprise® as described in the Architecture-Specific Information manual and after the connection with the installation system has been established, you are presented with the interface of SUSE Linux Enterprise's system assistant YaST. YaST guides you through the entire installation and configuration procedure.
For IBM POWER platforms, the system is initialized (IPL) as described in the Architecture-Specific Information manual. For a network installation, SUSE Linux Enterprise Server does not show a splash screen or boot loader command line on these systems. During the installation, load the kernel manually. YaST starts with its installation screen as soon as a connection has been established to the installation system via VNC, X, or SSH. Because there is no splash screen or boot loader command line, kernel or boot parameters cannot be entered on screen, but must be included in the kernel image using the mkzimage_cmdline utility. See the Preparation chapter in the Architecture-Specific Information manual for a description.
![[Tip]](admon/tip.png) | IBM POWER: The Next Steps |
|---|---|
To install, follow the description of the installation procedure with YaST starting from Section 3.6, “Language”. | |
