#
# this config file was automatically generated
# using lirc-0.6.1 on Fri Sep  1 22:34:30 2000
#
# contributed by Bastian
#
# brand:             pace
# model:             mss 300 serie
# supported devices: ?
#

# Pace remote controls send two header signals before the acutal
# code. The length of one header signal is approx. 750 3000. With the
# chosen tolerance values LIRC confuses the header signals with a
# 0. In this case this is ok, because otherwise you would have to
# create a raw_codes config file that does not support toggle
# bits. But it might cause problems if you want to send these signals.

begin remote

  name  pace
  bits           10
  flags SPACE_ENC|CONST_LENGTH
  eps            30
  aeps          100

  one           658  6930
  zero          658  4402
  ptrail        661
  pre_data_bits   2
  pre_data       0x0
  gap          121416
  toggle_bit      3


      begin codes
	'1'                   0x0000000000000301    # 1
	'2'                   0x0000000000000102    # 2
	'3'                   0x0000000000000303    # 3
	'4'                   0x0000000000000104    # 4
	'5'                   0x0000000000000305    # 5
	'6'                   0x0000000000000106    # 6
	'7'                   0x0000000000000307    # 7
	'8'                   0x0000000000000108    # 8
	'9'                   0x0000000000000309    # 9
	'0'                   0x0000000000000100    # 0
	'UP'                  0x000000000000031A    # Up
	'LEFT'                0x0000000000000116    # Left
	'RIGHT'               0x0000000000000311    # Right
	'DOWN'                0x000000000000010B    # Down
	'MENU'                0x0000000000000317    # Menu
	'OK'                  0x000000000000011F    # Ok
	'BACK'                0x000000000000030F    # Back
	'RED'                 0x000000000000010E    # Red
	'GREEN'               0x000000000000030C    # Green
	'YELLOW'              0x0000000000000112    # Yellow
	'BLUE'                0x000000000000030D    # Blue
      end codes

end remote
